Gage settings
68 MMS
®
Inspection DPM High
10.2.2 Display brightness
You can adjust the brightness for the inside, sun, night and Dimmed brightness
modes.
Navigation
: Selects – parameter/value
: Confirms – selection/setting
:Exits – page/menu
: Cancels – leaves page/menu without saving the changes
To set the brightness values
1. Open the selection menu: Main menu ( ) > Gage Settings > OK >
Display Settings > OK > Set Brightness > OK.
2. Select the desired brightness mode:
> OK
.
3. Set the desired value:
>OK
.
The higher the set value the higher the brightness.
The setting is finished.
Repeat the steps 2. and 3. for the other brightness modes.
What you can do next
Go to the Measurement view: 3x > , measure, see page 28.
Make further display settings: 1x .
Make further gage settings: 2x .
Set time period from which the display is dimmed, see page 71.
To Next Page
Loading...
