21 Settings
PIOX S72* 21.9 Key lock
195
UMPIOX_S72xV1-9EN, 2022-05-15
21.9 Key lock
An ongoing measurement can be protected from an inadvertent intervention by means of a key lock.
Definition of a key lock code
• Select the menu item System settings in the program branch Special functions.
• Press ENTER.
•Select Key lock.
• Press ENTER.
• Enter a 6-digit key lock code.
• Press ENTER.
Intervention in the measurement
If the key lock is activated, the message Key lock activated will be displayed for a few seconds when pressing a key.
In order to interrupt a measurement, the key lock has to be deactivated.
• Press .
•Select Show parameters.
• Press ENTER.
• Deactivate the key lock.
Deactivation of the key lock
• Select the menu item System settings in the program branch Special functions.
• Press ENTER.
•Select Key lock.
• Press ENTER.
• Enter a 6-digit key lock code.
• Press ENTER.
Disabled functions with activated key lock
The following table gives an overview of the transmitter functions that are not available when the key lock is activated.
Special functions\System settings\Key lock
Do not forget the key lock code!
Special functions\System settings\Key lock
measurement not started measurement started
• parameter input
• modification of settings (e.g., measuring modes)
• deletion of the data logger
• setting of time/date
• start of the measurement (start-up)
• modification of settings that can be changed during the
measurement (e.g., language selection)
• triggering of snaps
• stop of totalizers
• reset of totalizers
• stop of measurement
To Next Page
Loading...
Need help?
General
