FLIR ThermaCAM P20 - Installation & Operation of ThermaCAM Connect 3; Introduction; Installation

7 Installation & operation of
ThermaCAM Connect 3
7.1 Introduction
FLIR Systems AB’s software ThermaCAM Connect 3 lets you download images
from your infrared camera to your desktop or laptop computer.
7.2 Installation
NOTE: This installation tutorial applies to ThermaCAM Connect 3 only.
7.2.1 Software requirements
7.2.1.1 Camera
ThermaCAM Connect 3 will only work with these camera configurations:
■
P/S series cameras: boot2 version 2.4.2.1 (or higher)
■
P/S series cameras: appl version 2.4.4.1 (or higher)
To check the version of boot2/appl, select Setup → Camera Info in the camera.
Make sure the version number of the module ‘boot2'/'appl’ is as stated above.
7.2.1.2 PC
Serial communication (RS-232) between PC and camera is supported on the fol-
lowing operating systems:
■
Windows 98 Second Edition
■
Windows Me
■
Windows NT 4, Service Pack 6
■
Windows 2000
■
Windows XP
USB and connections between PC and camera is supported on the following op-
erating systems:
■
Windows 98 Second Edition
■
Windows Me
■
Windows 2000
■
Windows XP
NOTE: Before you install the application, please close all other programs on the computer. Make sure
ThermaCAM Connect 3 is installed before connecting the camera to the USB or port.
18 Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004