10 Electrical power system
The camera’s electrical power system consists of the following parts:
■
a removable battery
■
a power supply
■
an internal battery charger
■
a stand-alone, external battery charger
The camera may powered either by using the battery, or by using the power
supply. When using the power supply, the battery will – if it’s inserted in the battery
compartment – automatically be charged. You can still use the camera during
charging.
NOTE: Please note the following:
■ The camera is shipped with charged batteries. To increase the battery life, the battery should be
fully discharged and charged a couple of times. You can do this by using the camera until the
battery is fully depleted.
■ The same power supply can be used for both the internal battery charger and the external battery
charger.
■ The operation time of the camera when run on a battery is substantially shorter in low temperatures.
The removable battery gives an operation time of approx. 1.5–2 hours. When
Battery low is displayed on the screen it is time to charge the battery.
10.1 Internal battery charging
To charge the battery internally, follow the instructions below.
ActionStep
Make sure that the battery is correctly inserted into the camera.
1
Connect the power supply cable to the camera.
2
The message Charging battery will appear on the screen.
3
While charging, the battery status symbol will pulse until the battery is fully
charged.
4
Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004 55
To Next Page
Loading...
Need help?
General
