SEE ALSO: For more information about object parameters, see section 16 – Thermographic
measurement techniques on page 80.
9.2.4.4 Manual adjust / Continuous adjust
■
Point to Manual adjust and press the joystick to put the camera in manual adjust
mode. You can now change level and span by first pressing the C button repeat-
edly (to change the function of the joystick to level/span), and then change
level or span by moving the joystick up/down and left/right, respectively
■
Point to Continuous adjust and press the joystick to put the camera in automatic
mode, continuously optimizing the image for best level and span
SEE ALSO: For more information about the Level/Span command, see section 9.2.4.3 – Level/Span
on page 46.
9.2.4.5 Palette
10392003;2
Figure 9.20 Palette dialog box
Point to Palette and press the joystick to display a dialog box where you can
change the color palette.
Figure 9.21 Explanations of the Palette dialog box
CommentsValueLabel
Move the joystick left/right to
change the palette.
Configuration-dependent
Palette
Move the joystick left/right to
reverse the current palette.
■
Yes
■
No
Inverted
9.2.4.6 Hide graphics
Point to Hide graphics and press the joystick to hide all on-screen graphics (e.g.
result table, status bar etc.). To display the graphics again, press the joystick or the
C button.
9.2 – Menu system
Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004 47
To Next Page
Loading...
