5320A
Users Manual
3-6
Table 3-1. Front-Panel Features (cont.)
Item Description
K TPUQ
K
Output adjustment controls; if any of these keys are
pressed or the knob is rotated, a digit on the output area of
the display is highlighted. The output increments or
decrements as the knob is rotated. If a digit rolls past 0 or
9, the digit to its left or right is carried.
When making a menu selection, pushing in on the knob is
equivalent to pressing the SELECT softkey. When editing
a number, pressing in on the knob will switch between
moving the cursor between characters and changing the
selected character’s value. Arrow icons above and below
the selected digit indicate which of the two modes are
active.
The
T and U keys adjust the magnitude of changes by
moving the highlight between the digits. The
P and Q
keys increment and decrement respectively the value of
the highlighted digit.
L O S Controls the application of output signals to the output
terminals. The O and S have LEDs imbedded in them
to indicate whether or not the output signal is applied
(Operate) or not (Standby).
M 0 through 9 B D C
E
Provides number keys for keying in the output amplitude,
selecting menu items, and other data such as the time and
date. To enter a value, press the digits of the output value,
a multiplier key if necessary, an output function key, and
then press E.
XWWarning
To avoid electric shock, ensure the Calibrator is in standby
before making connections to the following terminals:
• HI and LO OUTPUT terminals for the Voltage function (up 600 V ac
or dc in operate mode).
• L, PE and N terminals (line voltage is present when in operate for the
RCD and Z
L
modes).
To Next Page
Loading...
