EasyManua.ls Logo

Fluke DTX-MFM2 - Page 224

Fluke DTX-MFM2
320 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DTX Series CableAnalyzer
Technical Reference Handbook
10-8
-continued-
Figure 10-4. Network Connectivity Results Screen (DHCP example for twisted pair)
amd06.eps
A
Speeds supported by the switch or hub: 10 Mbit, 100 Mbit, 1000 Mbit. The
current speed is green. Arrows show the connection's duplex
configuration:
B
PoE shows if the device appears to support Power over Ethernet. The tester
requests power from suspected PoE devices. PoE is red if the device did not
supply power during the test.
Fiber shows for a fiber link.
C
Crossover indicator (twisted pair only):
Green: either the cable is straight-through, or the cable is a crossover
and the hub or switch crossed pairs 12-36 (MDI on the Negotiation
Details screen).
Orange: the tester compensated for a crossover cable by crossing pairs
12-36 (MDI-X on the Negotiation Details screen).
4
3
2
8
9
6
1
5
7

Table of Contents

Other manuals for Fluke DTX-MFM2

Related product manuals