Fluke DTX-MFM2 - Creating Folders

Getting Acquainted
Overview of Memory Features
1-27
1
amd62f.eps
Figure 1-11. Inserting and Removing the Memory Card
Creating Folders
You can organize your test results by saving them in folders.
To create a folder:
1 DTX-1800, DTX-1200: Insert a memory card into the
tester.
2 Turn the rotary switch to SETUP.
3 Use D to highlight Instrument Settings; then press
H.
4 Press D to highlight Current Folder; then press
H.
5 DTX-1800, DTX-1200: Press J if necessary if you
want to create the folder on the memory card.
6 Press L Create Folder.
7 Use JKL, BCAD, and H to
enter a folder name. Press
N when you are done.
8 Use AD to highlight the new folder in the
list of folders; then press H.
Push card in until
LED turns on
Inserting the card
Removing the card
Push card in to
release it