DTX Series CableAnalyzer
Technical Reference Handbook
13-36
Power
Notes
You do not need to fully discharge the battery
before recharging it.
The battery will not charge at temperatures
outside of 0 °C to 45 °C (32 °F to 113 °F). The
battery charges at a reduced rate between 40 °C
and 45 °C (104 °F and 113 °F).
• Main unit and remote: Lithium-ion battery pack,
7.4 V, 4000 mAh
• Typical battery life: 10 to 12 hours
• Charge time (with tester off): 4 hours (below 40 °C)
• AC adapter/charger, USA version: Linear power supply;
108 V ac to 132 V ac input; 15 V dc, 1.2 A output
• AC adapter/charger, international version: Switching
power supply; 90 V ac to 264 V ac input; 15 V dc;
1.2 A output
Memory backup power in main unit: Lithium battery
Typical life of lithium battery: 5 years
Electromagnetic Compatibility
Emissions: EN 61326-1, Class A
Immunity: EN 61326-1
Input Ratings
A DTX Series tester and remote are designed to measure
unpowered cables. The inputs are protected against
continuous, current-limited telco voltages
(<100 mA) and can withstand occasional overvoltages of
less than 30 V rms (42 V peak, 60 V dc).
Certification and Compliance
CSA Standards
CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997 and
CAN/CSA-C22.2 No. 1010.1 2000 (2
nd
edition) Safety
Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use, Part 1: General Requirements.
;
N10140
Conforms to relevant Australian
standards
P
Conforms to relevant European Union
directives.
)
Listed by the Canadian Standards
Association.
To Next Page
Loading...
