Fluke DTX-MFM2 - Step 1: Checking the Battery Status and Verifying Operation with Twisted Pair Adapters

DTX Series CableAnalyzer
Technical Reference Handbook
2-6
Step 1: Checking the Battery Status and
Verifying Operation with Twisted Pair Adapters
You should check the tester and smart remote’s battery
status and verify all equipment is in good working order
before going to the job site.
1-1 Connect the tester and smart remote together as shown
in Figure 2-3.
1-2 Turn the rotary switch to SPECIAL FUNCTIONS.
1-3 Use D to highlight Battery Status; then press
H. Press I when you are done.
1-4 Use D to highlight Self Test; then press H.
1-5 Press Pto start the self test.
Note
You can also check the battery status by
connecting channel adapters with a patch cord, or
by connecting the tester and smart remote
through a link.
amd41f.eps
Figure 2-3. Battery Status and Self Test Connections for
Twisted Pair Adapters
Permanent link
adapter
Channel
adapter
TEST
LOW BATTERY
TONE
TALK
FAIL
TEST
PASS
TALK
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3