Maintenance and Specifications
Specifications
13-37
13
Safety
CAN/CSA-C22.2 No. 1010.1-92 + Amendment 2: 1997;
Overvoltage Category II, Pollution degree 2, 30 V.
EN61010, 2nd Edition, MEASUREMENT (Installation)
CATEGORY I, Pollution Degree 2 per IEC1010-1 refers to the
level of Impulse Withstand Voltage protection provided.
Equipment of MEASUREMENT CATEGORY I is for
measurements performed on circuits not directly connected
to mains.
Regulatory Information
This equipment generates, uses, and can radiate radio
frequency energy, and, if not installed and used in
accordance with the manual, may cause interference to
radio communications. It has been tested and found to
comply with the limits for a Class A digital device pursuant
to Part 15, Subpart J of the FCC rules, which are designed to
provide reasonable protection against such interference
when operated in a commercial environment. Operation of
the equipment in a residential area is likely to cause
interference, in which case the user, at his own expense,
will be required to take whatever measures may be
required to correct the interference.
Laser Classification and Safety for DTX-MFM2, DTX-
GFM2, and DTX-SFM2 Fiber Modules
OUTPUT port: Class 1
VFL port: Class 2
Complies with EN60825-1 and EN61010-1 (CE) and CFR21
Memory for Test Results
Internal memory stores up to 250 Cat 6 Autotest results,
including graphical data.
The 16 MB memory card included stores up to 500 Cat 6
Autotest results, including graphical data.
1 MB Flash EPROM allows software and test limit updates.
LinkWare software lets you upload Autotest results to a PC
from the tester or a memory card reader.
To Next Page
Loading...
Need help?
General
