Fluke DTX-MFM2 - Working with Folders; Creating a New Folder; Changing Folders

DTX Series CableAnalyzer
Technical Reference Handbook
12-4
Working with Folders
You can create folders for each job to organize your test
results. The tester saves test results in the folder you select.
Creating a New Folder
To create a new folder:
1 Turn the rotary switch to SETUP.
2 Use D to highlight Instrument Settings; then
press
H.
3 DTX-1800, DTX1200: Verify that the Result Storage
Location shows the location where you want the new
folder. Change the location if necessary.
4 On the Instrument Settings screen, use D to
highlight Current Folder; then press H.
5 Press J Create Folder.
6 Use the softkeys, BCAD, and H to enter
a folder name. Press N when you are finished.
Changing Folders
To change the current folder:
1 Turn the rotary switch to SETUP.
2 Use D to highlight Instrument Settings; then
press H.
3 DTX-1800, DTX1200: Verify that the Result Storage
Location shows the correct location. Change the
location if necessary.
4 On the Instrument Settings screen, use D to
highlight Current Folder; then press
H.
5 Use AD to highlight a folder name; then
press H.
Note
Changing folders from the View Results screen in
SPECIAL FUNCTIONS does not change the current
folder in SETUP.