This function is intended to module the dose obtained in order to overcome the shield created by the spine when the
tube head is in the posterior position.
The black beam should be centered with the phantom support.
By keeping pressed the BACK key for 5 s
the system enters Service Mode.
Service function can be selected using
the INCREASE or DECREASE keys on the RIGHT side of the display.
Scroll the menu until kV Mod Offset is displayed.
Press the PROGRAM key to enter kV Mod Offset.
Press the INCREASE or DECREASE keys on the LEFT side of the display.
The kV Mod Offset value have been set at 0; this value cannot be used for this type of
equipment..
Press the BACK key to exit kV Mod Offset.
Press the TEST Mode key to exit SERVICE MODE.
To Next Page
Loading...
