PostBase Fusion
156
Installing the rocker with moistening felt
The rocker features two clips that engage on
the two bolts at the sealer.
• Fit the new rocker such that one leg of the
leg spring is located in the rocker groove
and the other leg in the sealer slot.
• Hold sealer in place, and exerting moderate
pressure, push the rocker onto the sealer
such that the two clips engage on the bolts.
Check
• Check the correct seat:
– The absorption felt must be perpendicu-
larly suspended in the fluid reservoir. Its
lower edge should roughly reach the bot-
tom.
– The gap between rocker and sealer
housing must be uniform. (The rocker
must neither jut out nor touch the hous-
ing.)
• Fill with SEALIT sealing fluid
(see page 152).
• Connect the sealer to the postage meter
(see page 24).
Leg spring
Bolt
Clip
Absorption felt
Rocker
Uniform gap
To Next Page
Loading...
