3.4 Programming Mode
3-26
Basic key operation
Turn the inverter ON. It automatically enters Running mode in which you press the key to switch
to Programming mode. The function selection menu appears.
Use the and keys to select “I/O Checking” (
4.i_o
).
Press the key to skip in menu number units.
Press the key to proceed to a list of I/O checking items (e.g.,
4_00
).
Use the and keys to display the desired I/O checking item, then press the key.
Press the key to skip the to the I/O checking item +10. When the end is reached, the display
returns to the beginning of the same function code group.
The corresponding I/O checking data appears. For the item
4_00
or
4_01
, using the and
keys switches the display method between the segment display (for external signal information in
Table 3.4-9) and hexadecimal display (for I/O signal status in Table 3.4-10).
Press the key to return to the list of I/O checking items. Press the key again to return to the
menu.
To Next Page
Loading...
