3.4 Programming Mode
3-37
OPERATION USING THE KEYPAD
3.4.6 Reading alarm information “Alarm Information: 6.al”
Menu number 6 “Alarm Information: 6.al” shows the causes of the past 4 alarms with an alarm code. Further, it is
also possible to display alarm information that indicates the status of the inverter when the alarm occurred. Fig.
3.4-3 lists “ “Alarm Information” menu transition”. The menu transition in “Table 3.4-14” is shown in “Alarm
Information” display content.
Fig. 3.4-3 “Alarm Information” menu transition
Basic key operation
Turn the inverter ON. It automatically enters Running mode in which you press the key to switch
to Programming mode. The function selection menu appears.
Use the or key to display “Alarm Information” (
6.al
).
Press the key to skip in menu number units.
Press the key to proceed to the list of alarm codes (e.g.,
1.0l1
).
In the list of alarm codes, the alarm information for the last 4 alarms is saved as an alarm history.
Each time the or key is pressed, the last 4 alarms are displayed beginning with the most
recent one in the order “
1
.”, “
2
.”, “
3
.”, “
4
.”.
By pressing the key, the display returns to the latest alarm history.
Press the key with an alarm code being displayed.
The monitor number (e.g.
6_00
) and the inverter status information (e.g. Output frequency) at the
time of the alarm occurrence alternately appear at approx. 1-second intervals. Pressing the /
keys displays other monitor numbers (e.g.,
6_01
) and the status information (e.g., Output current)
for that alarm code.
By pressing the key at this time, the display can be switched between the monitor number and
symbol.
Press the key to return to the list of alarm codes. Press the key again to return to the menu.
Running status info at the time
an alarm occurred
Switching atapprox.
1-second intervals
Switching atapprox.
1-second intervals
Switching atapprox.
1-second intervals
To Next Page
Loading...
