Fuji Electric FRENIC MEGA G2 Series - Page 362

5.3 Description of Function Codes 5.3.2 E codes (Extension terminal functions)
5-178
Monitor item
Monitor
example
LED indication
Unit
Meaning of displayed value
E43 data
Analog signal input
monitor
82.00
HzAkW
-
An analog input to the inverter in a format
suitable for a desired scale.
17
Current position pulse
1234
HzAkW
Pulse
Current position pulse
21
Positioning deviation pulse
2345
HzAkW
Pulse
Command current position and feedback
current position deviation indicated with
user value
22
Torque current
48
HzAkW
%
Torque current command value or
calculated torque current
23
Flux command value
50
HzAkW
%
Magnetic flux command value
(Available only under vector control)
24
Integral power
consumption
100.0
HzAkW
kWh
100
(kWh) hour- wattInput
value Indicated =
25
Winding diameter
1234
HzAkW
mm
Winding diameter calculation result display
for constant surface speed control
26
Position control start
position
1234
HzAkW
-
Position when run command turns ON or
“POS-SET” command turns ON indicated
with user value
27
Stop target position
2345
HzAkW
-
Stop target position indicated with user
value
28
PID deviation
1.00.
HzAkW
-
PID command value and PID feedback
value deviation converted into physical
quantities of the object to be controlled
29
Torque bias
25
HzAkW
%
Torque bias value display
30
Estimated inertia
acceleration/
deceleration time
conversion value
1.234
HzAkW
s
Display of estimated inertia result in logic
acceleration/deceleration time
See function code P24.
31
Customizable logic output
82.00
HzAkW
-
Display of output content for specific
customizable logic step
See function codes U98, U99.
32
 ON,  OFF
Note: The function code applied when the motor changes will also change.