Fuji Electric FRENIC MEGA G2 Series - Page 369

5.3 Description of Function Codes 5.3.2 E codes (Extension terminal functions)
5-185
FUNCTION CODES
Chap 5
FUNCTION
CODES
F Codes
E Codes
C Codes
P Codes
H Codes
A Codes
b Codes
r Codes
J Codes
d Codes
U Codes
y Codes
K Codes
E61, E62,
E63, E66 data
Function
Description
5
PID feedback value
Inputs feedback values such as temperature and pressure under PID
control.
100 %/full scale.
Effective range: -110% to 110%
6
Ratio setting
Multiplies the final frequency command value by this value, for use in
the constant line speed control by calculating the winder diameter or in
ratio operation with multiple inverters.
100 %/full scale.
Effective range: -200% to 200%
7
Analog torque
limiter A
Used when analog inputs are used as torque limiters.
( Function code F40)
200 %/full scale.
Effective range: -400% to 400%
8
Analog torque
limiter B
Used when analog inputs are used as torque limiters.
( Function code F40)
200 %/full scale.
Effective range: -400% to 400%
9
Torque bias
Used when analog inputs are used as torque bias.
( Function code H154)
200 %/full scale.
Effective range: -400% to 400%
10
Torque command
Analog inputs to be used as torque commands under torque control.
( Function code H18)
Effective range: -400% to 400%
11
Torque current
command
Analog inputs to be used as torque current commands under torque
control. ( Function code H18)
Effective range: -400% to 400%
12
Acceleration/decele
ration time ratio
setting
Multiplies the ratio based on the analog input amount by the
acceleration/deceleration time.
( Function code F07)
Effective range: -400% to 400%
13
Upper limit
frequency
The frequency obtained by multiplying the maximum frequency by the
analog input amount is used as the upper limit frequency.
( Function code F15)
Effective range: 0% to 100%
14
Lower limit
frequency
The frequency obtained by multiplying the maximum frequency by the
analog input amount is used as the lower limit frequency.
( Function code F15)
Effective range: 0% to 100%
15
Auxiliary frequency
setting 3
This is added immediately after adding auxiliary frequency setting 1.
100%/full scale (see block diagram)
Effective range: -100% to 100%
16
Auxiliary frequency
setting 4
This is added immediately after adding auxiliary frequency setting 2.
100%/full scale (see block diagram)
Effective range: -100% to 100%