Fuji Electric FRENIC MEGA G2 Series - 11.18 External Frequency Command Potentiometer (External)

11.18 External Frequency Command Potentiometer (External)
11-82
11.18 External Frequency Command Potentiometer (External)
An external frequency command potentiometer may be used to set the drive frequency. Connect the potentiometer
to control signal terminals [11] through [13] of the inverter as shown in Fig. 11.18-1.
■ RJ-13 Type: RJ-13 (BA-2 B-characteristics, 1 kΩ)
■ WA3W-1kΩ Type: WA3W-1kΩ (3W B-characteristics)
[13]
[12]
[11]
+10VDC
0V
External volume
3
2
1
Inverter
Fig. 11.18-1 External dimensions and connection example for external frequency command potentiometer
(Note) The nameplate and dial must be ordered separately (parts available from Fuji Electric Technica Co., Ltd.)
(Note) The nameplate and dial must be ordered separately (parts available from Fuji Electric Technica Co., Ltd.)
Shaft
Type:
Type:
Panel hole size
Knob type:
Dial plate type:
Panel hole size