11.22 Built-in Option Card Types and Ports in Which They Can be Installed
11-95
SELECTING PERIPHERAL EQUIPMENT
Function code settings
To specify run commands and frequency commands from PROFIBUS, it is necessary to set inverter function codes.
A list is shown in Table 11.22-8.
Table 11.22-8 Function code settings required to enable run and frequency commands from PROFIBUS
G1, GX1 compatibility
mode
0: Disable (factory default)
1: Reserved (cannot be set)
2: Enable (G1 compatible)
3: Enable (GX1 compatible)
Run, frequency
commands from
PROFIBUS
Select from the following.
Run, frequency
command from rotor
Unnecessary to change from factory
default
Terminal [X□] function
selection
(□: terminal number)
Set to other than
24, 1024 (other
than “LE”
selection).
(Applies to all
terminal X function
codes.)
Even when “LE” is selected, the y98
setting will be valid if the terminal is
turned ON.
When “LE” is set to OFF, the y98 setting
will be invalid, and both run and
frequency commands will be specified
from the inverter.
Other related function codes are shown in the following table.
Table 11.22-9 Related inverter function codes
Operation selection
when PROFIBUS
communication error
detected
Operation timer when
PROFIBUS
communication error
detected
Refer to the communication card
instruction manual.
PROFIBUS station No.
selection
Station Nos. that are valid when the
rotary switch on the PCB is set to “00”
Write function code
assignment 1 to 8
Sets function code for data mapped I/O
writing.
Same as PNU915
Read function code
assignment 1 to 8
Sets function code for data mapped I/O
reading.
Same as PNU916
To Next Page
Loading...
