Fuji Electric FRENIC MEGA G2 Series - Page 97

3.3 Running Mode
3-13
OPERATION USING THE KEYPAD
Chap 3
Setting up the primary frequency command with and keys under PID dancer control
When function code F01 is set to “0” ( / keys on keypad) and frequency setting 1 is selected as a main setting
(when disabling the frequency setting command via communications link, multistep frequency command, and PID
control), switching the LED monitor to the speed monitor in Running mode enables you to modify the main setting
with the / keys. When the keypad is set to Programming or Alarm mode, changes to the main settings cannot
be made with the / keys. Switch to Running mode. Table 3.3-7 below lists the combinations of the commands.
Table 3.3-7 illustrates how main setting command (1) entered with the keypad is translated to final frequency
command (2).
The setting procedure is the same as that for setting of a usual reference frequency.
In the case of conditions other than the above, the following is displayed by pressing the / keys.
Table 3.3-7 Main settings (frequency settings) specified with / keys and required settings
PID
control
(Mode
selection)
J01
LED
monitor
E43
Frequency
setting 1
F01
Multistep
frequency
SS2
Multistep
frequency
SS1
Select
link
operation
LE
Cancel PID
control
Hz/PID
Pressing / keys
controls:
3
0
0
OFF
OFF
OFF
ON
(PID disabled)
Main settings (frequency
settings) specified with keypad
Other than above
Primary command (frequency)
currently selected
Not required
OFF
(PID enabled)
PID output
(as final frequency command)
Main settings
specified with keypad
SS2,1 = OFF