8.4 OST Wizard
servers, configuring LSUs (logical storage units), and adding OST users. The wizard also
provides a link for downloading and installing the OST Plug-in on your backup host.
Additional Information
l The OST Wizard is available in ETERNUS CS800 and Multi-Protocol configurations only.
l If you plan to use Concurrent Optimized Duplication, you should complete the
Replication wizard before beginning the OST wizard (see "Replication Wizard" on page
152).
l You cannot use the OST wizard to edit existing storage servers or LSUs. For more
information about working with OST, see "OST Configuration" on page 227.
To begin the OST wizard, on the Wizards menu, click OST.
Step 1: About
1. Read the information about the wizard (see "OST Wizard: About" on page 147).
The About page displays the status of the OST service. OST settings can be configured
in Ready, Stopped, or Verifying state. The OST server is available for backup only in
Ready state.
2. Click Next to continue.
At any time while using the wizard, you can click Previous to return to the previous
step.
Figure 111: OST Wizard: About
Step 2: Add Storage Servers
1. Under Add Storage Server, enter information about the storage server (see "OST
Wizard: Add Storage Servers" on page 149):
ETERNUS CS800 147
To Next Page
Loading...
