Fujitsu ETERNUS CS800 S6 - Page 252

10.5 Replication Configuration
Additional Information
l For more information about data replication, or to perform data replication, see
"Replication" on page 340.
l If the ETERNUS CS800 is configured as a replication target and replication is performed
across a public network, with the source and target located behind NAT-enabled
routers, you must specify a NAT IP address for the ETERNUS CS800 on the Network
page (see "Configuring Interface IP Addresses" on page 299).
To access the Replication Configuration page, click the Configuration menu, and then click
the Replication tab (see "Replication Configuration Page" on page 252).
Figure 176: Replication Configuration Page
Tasks
Use the Replication Configuration page to perform the following tasks:
l View information about configured replication target systems (see "Target System List"
on page 253).
l Add, edit, or delete a replication target (see "Adding a Replication Target" on page
253,"Editing a Replication Target" on page 255, or "Deleting a Replication Target" on
page 257).
l Pause or resume replication to a target (see "Pausing or Resuming Replication to a
Target" on page 257).
l Configure a constant replication throttle (see "Enabling System Throttling" on page
257).
l View information about allowed replication source systems (see "Source ETERNUS
CS800 List" on page 258).
l Add or delete an allowed replication source (see "Adding a Replication Source" on
page 259 or "Deleting a Replication Source" on page 260).
l Specify the maximum number of received snapshots to retain for each source (see
"Changing the Maximum Number of Snapshots" on page 260).
ETERNUS CS800 252