1 Introduction
1.1 Preface
This manual introduces the FUJITSU Storage ETERNUS CS800 enhanced data protection
system and provides information about:
l Features and hardware
l Installation
l System operations
l Configuration
l Web interface
l Basic troubleshooting
l Basic spare parts replacement procedures
This manual applies to the ETERNUS CS800 V3.2 software which supports the
ETERNUS CS800 S6 hardware. For hardware related topics for an ETERNUS CS800
S2/S3/S4/S5 system, please continue to use the appropriate manual.
Audience
This manual is written for ETERNUS CS800 system operators and system administrators.
It is useful for the audience to have a basic understanding of Linux.
Document organization
Following is a brief description of chapter contents.
l Chapter "Important Information" on page 16 provides essential information regarding
safety when working on your ETERNUS CS800.
l Chapter "System Description" on page 27 provides an overview of the ETERNUS
CS800 system.
l Chapter "Hardware Description" on page 43 describes the hardware components of the
ETERNUS CS800 system and instructions for turning on/off the system.
l Chapters "Rack Requirements" on page 79 , "Installing the ETERNUS CS800 S6
Modules" on page 81 and chapter "Initial Configuration, Connecting with the Network" on
page 107 describe all steps to install the hardware for the ETERNUS CS800 S6 system
and the initial software configuration.
l Chapter "Remote Management" on page 133 describes how to use the management
ETERNUS CS800 11