10.6 PTT Configuration
l To enable or disable a physical library, select it in the list, and then click Enable or
Disable. (You can also right-click a library to enable or disable it.)
l To use a physical library, it must be enabled. If you enable or disable a library, all tape
drives in the library are also enabled or disabled.
l To view the drives in an attached library, select the library in the list. All drives in the
selected library display below.
l To enable or disable tape drives, select one or more drives in the list, and then click
Enable or Disable. (You can also right-click a drive to enable or disable it.)
l To use a tape drive, it must be enabled. To enable a drive, the parent library must be
enabled.
l To remove a physical library from the list, first disconnect the Fibre Channel cables that
connect the library to the ETERNUS CS800, and then click Scan.
l To update the libraries or drives list with the latest information, click Refresh.
10.6.2 Backup Application Specific
The Backup Application Specific page allows you to create and manage authenticated
users for use with the path to tape capability.
The following applications are supported for backup application specific path to tape:
l Symantec NetBackup
l Symantec Backup Exec
l EMC Networker
EMC NetWorker 8.1 and later do not support Backup Application Specific
Path to Tape.
l Oracle Secure Backup
l ASG-Time Navigator
You must dedicate a partition within the ETERNUS CS800 for use with
NetBackup Direct to Tape (Path to Tape). The partition cannot be shared with
another backup application.
CAUTION!
The virtual media changer and tape drives must be assigned to the backup server (on
the SAN) being used for Backup Application Specific path to tape functionality.
To access the Backup Application Specific page, on the PTT page, click the Backup
Application Specific tab (see "Backup Application Specific Page" on page 283).
282 ETERNUS CS800
To Next Page
Loading...
Need help?
General