Figure 303: Removing a 2.5-inch HDD
Removing the non-defective HDD Modules
CAUTION!
If you need to remove non-defective HDD modules, consider the following:
l Do never remove a non-defective HDD module during operation of the
ETERNUS CS800
l All HDD modules (drives) must be uniquely identified so that they can be
reinstalled in their original mounting locations later. If this is not done, existing
data can be lost.
16.2 Storage Subsystem
The following chapter applies for ETERNUS CS800 JX40 S2 and ETERNUS CS800
DX100 S3 storage systems.
The Hard Disk Drive (HDD) used in the JX40 S2 storage module and in the DX100 S3 is a
3.5" NL-SAS HDD with 7200 rpm.
CAUTION!
In order to avoid giving damages to the device by the static electricity of human body,
be sure to wear a wrist strap during the maintenance work. Hot Maintenance work
should be finished within 5 minutes (for preventing temperature rise).
ETERNUS CS800 473
16 Removal Replacement Procedures CRUs
To Next Page
Loading...
