Fujitsu ETERNUS CS800 - Page 474

16.2 Storage Subsystem
This component can be replaced, during operation of the system (Hot Maintenance).
The component cannot be replaced when the system is powered off.
When replacing the HDD unit, it is possible that the error log will display multiple errors,
due to a temporary disarray of the transmission route within the separation/connection
of the HDD unit. This is not a problem/error of the HDD unit or the device.
Removing
1. Press the latch of the disk drive and open the lock lever (1).
2. Hold the lock lever and pull the disk drive partway.
3. Take the hard disk drive out of the bay while supporting its bottom (2).
474 ETERNUS CS800