Fujitsu ETERNUS CS800 - 5.3 Cabling the ETERNUS CS800 S6 System

5.3 Cabling the ETERNUS CS800 S6 System
Figure 59: Fasten the JX40 S2 / DX100 S3 Storage Module in the Rack
For detailed information about PRIMECENTER rack, see the following manual:
http://manuals.ts.fujitsu.com/index.php?id=5406-5605-5606
For detailed information about installation of the server module in a PRIMECENTER rack,
see the following manual:
http://manuals.ts.fujitsu.com/index.php?id=5406-5635-5761-16765
For detailed information about installation of the JX40 S2 module in a PRIMECENTER rack,
see
http://support.ts.fujitsu.com/Manuals/ShowManuals.asp?LNG=COM&LNID=35&intlevel2=
118846&intFehlercode=0&NavIDs=
For detailed information about installation of the DX100 S3 module in a PRIMECENTER
rack, see the following manual:
http://support.ts.fujitsu.com/Manuals/ShowManuals.asp?LNG=COM&LNID=35&intlevel2=
118846&intFehlercode=0&NavIDs=
5.3 Cabling the ETERNUS CS800 S6 System
This chapter provides cabling diagrams for the different ETERNUS CS800 S6
configurations.
In order to set up the mains connection of the system with phase redundancy, the two power
supply units of each module must be connected to two different phases or to two different
circuits of the rack installation.
To safeguard backups in the event of a power outage, it is recommended that you
connect the ETERNUS CS800 S6 to a UPS (Uninterruptible Power Supply).
92 ETERNUS CS800