You can prevent mechanical damage and damage to the CD/DVD drive, as well as
premature CD/DVD wear, by observing the following suggestions:
l Only insert CDs/DVDs in the drive when needed and remove them after use.
l Store the CDs/DVDs in suitable sleeves.
l Protect the CDs/DVDs from exposure to heat and direct sunlight.
1.2.5 Laser Information
The FC HBAs (Fibre Channel Host Bus Adapters) comply with IEC 60825-1 laser class 1.
Class 1M Laser Product (PRO/10GbE SR Server Adapter)
CAUTION!
l The laser device must be factory serviced ONLY by the responsible manufacturer!
NO adjustments, service or maintenance is to be performed otherwise.
l Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
1.2.6 Batteries
CAUTION!
l Incorrect replacement of batteries may lead to a risk of explosion. The
batteries may only be replaced with identical batteries or with a type
recommended by the manufacturer (see the technical manual for the system
board).
l Do not throw batteries into the trash can. They must be disposed of in
accordance with local regulations concerning special waste.
l The battery must be disposed of in accordance with local regulations
concerning special waste.
l Replace the lithium battery on the system board in accordance with the
instructions in the technical manual for the system board.
l All batteries containing pollutants are marked with a symbol (a crossed-out
garbage can). In addition, the marking is provided with the chemical symbol of
the heavy metal decisive for the classification as a pollutant:
Cd Cadmium
Hg Mercury
Pb Lead
ETERNUS CS800 19
1 Introduction
To Next Page
Loading...
