Fujitsu ETERNUS CS800 - Contacts; Company

Editing the Fibre Channel Port Type
Edit the port type to change the mode of a Fibre Channel port to initiator or target mode.
You can change the port mode only on inactive connections:
l Before changing a Fibre Channel port type from initiator to target, unplug the Fibre
Channel port wire connection.
l Before changing a Fibre Channel port type from target to initiator, un-map any host
mapping on the Fibre Channel port, and unplug the Fibre Channel port wire connection.
To edit the Fibre Channel Port type:
1. Select the port in the list and click Edit.
2. Select the new port mode (Initiator or Target) in the drop-down box (see Figure "FC
Initiators and Targets Page" on page 358).
3. Click Update.
10.10 Contacts
The Contacts page allows you to enter company information. You can also enter individual
contact information for primary and secondary contacts.
To access the Contacts page, click the Configuration menu, and then click the Contacts
tab.
The Contacts page contains the following tabs:
l "Company" on page 359
l "Primary and Secondary" on page 360
10.10.1 Company
The Company page allows you to enter information about the company and location of the
ETERNUS CS800.
To access the Company page, on the Contacts page, click the Company tab (see
"Company Page" on page 360).
ETERNUS CS800 359
10 Configuration