10.9 System
10.9.4 FC Initiators and Targets
The FC Initiators & Targets page allows you to see all path to tape initiator and target ports
and their associated World Wide Port Numbers (WWPNs). You can also change a Fibre
Channel port to initiator or target mode.
To access the FC Initiators & Targets page, on the PTT page, click the FC Initiators &
Targets tab.
Figure 232: FC Initiators and Targets Page
Use the FC Initiators & Targets page to perform the following tasks:
l View information about initiator and target Fibre Channel ports (see "Fibre Channel
Initiators and Targets List" on page 358).
l Change the mode of a Fibre Channel port (see "Editing the Fibre Channel Port Type" on
page 359).
Fibre Channel Initiators and Targets List
The Fibre Channel Initiators & Targets section displays the following information for all
Fibre Channel ports:
l Alias - The alias of the Fibre Channel port.
l WWPN - The World Wide Port Number of the Fibre Channel Port.
l Port Type - The current mode of the Fibre Channel port (Initiator or Target).
Click Refresh to update the list with the latest port information.
The Backpanel Locations section displays a graphical representation of the Fibre
Channel ports as they appear on the rear of the system. The diagram shows the status of
each Fibre Channel port: Mapped Target (green), Unmapped Target (yellow), Active
Initiator (blue), or Inactive Initiator (orange).
358 ETERNUS CS800
To Next Page
Loading...
