Fujitsu ETERNUS CS800 - Page 204

10.2 NAS Configuration
Enable data
deduplication
Select the check box to enable data deduplication. Fujitsu
Technology Solutions recommends that you enable data
deduplication to optimize disk usage.
Data deduplication is enabled by default. You cannot
enable or disable data deduplication after the share is
added. If data duplication is disabled, then data
compression is also disabled.
Data deduplication is enabled by default. You cannot
enable or disable data deduplication after the share is
added. If data duplication is disabled, then data
compression is also disabled.
Export Protocol Select the export protocol for the share:
l CIFS - Select the CIFS option to use the share on a
Windows network.
l NFS - Select the NFS option to use the share on a
UNIX or Linux network.
3. (Optional) Under Replication Settings, specify replication settings.
For more information about configuring replication for a share, or to set up replication for
the share at a later time, see "Replication" on page 363.
4. Click Apply.
When you create a CIFS share, the initial permissions are the same as the default
permissions for a Windows 2003 share with the addition of an ACE (Access
Control Entry) that permits full access to the share for all authenticated users.
Administrators can choose to remove this full access ACE, set up custom
permissions, or leave the ACL (Access Control List) as it is if the server is set up
in a fully trusted environment.
Editing a NAS Share
Edit a NAS share to modify the settings for the share, for example, to change the description
of the share or to select different options.
To edit a NAS share:
1. Select the share and click Edit.
The Edit NAS Share & Replication Settings page displays (see "Edit NAS Share &
Replication Settings Page" on page 205).
204 ETERNUS CS800