Fujitsu ETERNUS CS800 - Page 218

10.3 VTL Configuration
Available Partitions The number of partitions that have been added to the system
and the maximum number of partitions that can be added.
Available Virtual Tape
Drives
The number of virtual tape drives that have been added to the
system and the maximum number of drives that can be
added.
Name The name of the partition.
Mode The current mode of the partition (Online or Offline).
Model The library model emulated by the partition.
Drive Model The tape drive model emulated by the virtual drives in the
partition.
Drives The number of virtual tape drives in the partition.
Host Mapping The current state of host mapping for the partition (Yes or
No). If no hosts have been mapped, click Map to map hosts
to partitions (see "Remote Host Mapping" on page 233).
Media The number of virtual tape cartridges in the partition. If no
cartridges have been created, click Create to add media (see
"Media Add" on page 224).
Slots The number of storage slots in the partition.
Deduplication The data deduplication state of the partition (Enabled or
Disabled).
Replication The current state of replication for the partition:
l Enabled - Replication is enabled.
l Send/Receive Sync ID - Cartridge Based Replication is
enabled.
l Configure - Click to configure replication for the partition
(see "Partitions" on page 216)
l Scheduled - Replication is scheduled for the partition.
Click to view or modify the schedule (see "Scheduling a
Share or Partition for Replication" on page 290).
Targets The targets the partition is configured to replicate to.
Click a column heading to sort the rows in the table by that column. Click the
column heading again to reverse the sort order.
Click the Information button [i] next to a partition to display detailed information
about the partition and recent replication activity.
218 ETERNUS CS800