In order to set up the configuration of AISConnect you have to click Apply –even if
you do not use a Proxy. This action also starts the AISConnect service.
Field Description
Server Enter the IP address of the HTTP proxy to be used to contact the AIS
server at the Fujitsu Service Centre.
Port Enter the port number of the HTTP proxy.
Authentication
Enabled
Activate the checkbox if the HTTP proxy requires authentication.
NTML
Authentication
Enabled
Activate the checkbox if the HTTP proxy requires NTLM (NT LAN
Manager) authentication.
Username Enter the user name for proxy authentication.
Password Enter the password for proxy authentication.
Country Select the country where your ETERNUS CS800 is located.
Table 23: AISConnect Information
Control
Use the Control page to stop or start the AISConnect service.
Figure 203: AISConnect Control Page
If the AISConnect service is stopped, call-home and dial-in functionality is disabled.
To stop or start the AISConnect service:
ETERNUS CS800 317
10 Configuration
To Next Page
Loading...
