1. Select a share or partition that is configured for Directory/File or Cartridge Based
Replication.
If multiple targets are configured, click the arrow next to the share or partition to display
all targets, and then select the desired target.
2. Click Queue.
Figure 238: Directory/File or Cartridge Based Replication Queue
The Directory/File or Cartridge Based Replication Queue displays the following
information for the share or partition:
File/Directory or Barcode The file/directory or cartridge to be replicated.
State The replication state for the file/directory or
cartridge.
Progress The percentage complete for replication of the
file/directory or cartridge.
Estimated Duration The estimated time it will take to complete
replication for the file/directory or cartridge.
The estimated duration may display as
unknown if replication has been very recently
initiated. After the system has enough
information to calculate a value, the estimated
duration will display.
Additional Information
l The contents of the Directory/File or Cartridge Based Replication Queue are
dynamic. Because of this, statistics are subject to change if items are added to the
queue.
ETERNUS CS800 379
11 Replication
To Next Page
Loading...
