11.4 Receive VTL
The target system will retain up to 10 replication snapshots (default setting) for
each replicated partition. Once 10 snapshots have been saved, the oldest
snapshot is deleted to make room for each new snapshot that is received. (To
change the maximum number of snapshots retained for each partition, see
"Changing the Maximum Number of Snapshots" on page 279).
Snapshots List
The Snapshots List displays all available snapshots that have been received from
configured replication sources. Snapshots are grouped by VTL partition. To see all available
snapshots for a partition, click the plus icon [+] next to the partition name.
The Snapshots List displays the following information about each snapshot:
Partition
Name
The name of the partition.
Source
System
The hostname of the system that the snapshot was sent from.
Started The time the most recent replication job was started.
Finished The time the most recent replication job finished.
Status The status of the most recent replication job (see "Replication and
Synchronization Status" on page 373). Click the status to display detailed
information about the most recent replication job.
Click a column heading to sort the rows in the table by that column. Click the
column heading again to reverse the sort order.
Recovering a Partition
Recover a VTL partition if the source system is unavailable and you need to access the
partition (for example, to continue performing backups). When you recover a partition, you
select a received snapshot. The ETERNUS CS800 uses the snapshot to recreate the
partition on the target system just as it was at the point in time when the snapshot was
saved.
To recover a partition, the target system must support the library emulation and
drive type used in the original partition. For a list of the available library emulations
and drive types on the target system, see "Adding a VTL Partition" on page 219.
To recover a partition:
394 ETERNUS CS800
To Next Page
Loading...
