3.2 Storage Modules
LED name LED status Description
IDENTIFY/SCU
READY
blinks green l Specifies the installation location of the
controller module.
l System Capacitor Unit (SCU) is charging.
DI (OUT)LINK/
FAULT
green The link between the DI (OUT) port and the
destination port has been established.
amber l The link between the DI (OUT) port and the
destination port is in error status.
l The ports to remove the mini SAS HD
cables between enclosures from are
indicated. This occurs while a drive
enclosure is being added.
blinks amber The ports to connect the cables are indicated.
This occurs while a drive enclosure is being
added.
READY/FAULT green The link between the DI (OUT) port and the
destination port has been established.
blinks green An error has occurred during startup.
amber The controller is performing the initial setup after
the power is turned on.
The controller is in error status.
blinks amber
MASTER green The controller is set as a Master CM.
CA FAULT amber The host interface is in error status.
LINK/FAULT green The link between the host interface port and the
destination port has been established.
amber The host interface port is in error status.
LANACCESS blinks green Data is being sent or received via the LAN port
(for operation management).
LANLINK green The link between the LAN port (for operation
management) and the destination has been
established.
Figure 38: Status and Meanings of Each LED (Controller)
68 ETERNUS CS800
To Next Page
Loading...
