Fujitsu SPARC Enterprise M3000 Service Manual

vi SPARC Enterprise M3000 Server Service Manual • March 2012
3.2 Failure Diagnostic Method 3–2
3.3 Checking the Server and System Configuration 3–4
3.3.1 Checking the Hardware Configuration and FRU Status 3–4
3.3.1.1 Checking the Hardware Configuration. 3–5
3.3.2 Checking the Software and Firmware Configurations 3–6
3.3.2.1 Checking the Software Configuration 3–7
3.3.2.2 Checking the Firmware Configuration 3–7
3.3.2.3 Downloading Error Log Information 3–7
3.4 Error Conditions 3–8
3.4.1 Predictive Self-Healing Tools 3–8
3.4.2 Monitoring Output 3–10
3.4.3 Messaging Output 3–10
3.5 Using Troubleshooting Commands 3–11
3.5.1 Using the showhardconf Command 3–11
3.5.2 Using the showlogs Command 3–14
3.5.3 Using the showstatus Command 3–15
3.5.4 Using the fmdump Command 3–16
3.5.4.1 fmdump -V Command 3–16
3.5.4.2 fmdump -e Command 3–17
3.5.5 Using the fmadm Command 3–17
3.5.5.1 Using the fmadm faulty Command 3–17
3.5.5.2 fmadm repair Command 3–18
3.5.5.3 fmadm config Command 3–18
3.5.6 Using the fmstat Command 3–19
3.6 General Oracle Solaris Troubleshooting Commands 3–19
3.6.1 Using the iostat Command 3–20
3.6.1.1 Options 3–20
3.6.2 Using the prtdiag Command 3–21

Fujitsu SPARC Enterprise M3000 Specifications

General

Brand	Fujitsu
Model	SPARC Enterprise M3000
Category	Server
Language	English