Contents vii
3.6.2.1 Options 3–21
3.6.3 Using the prtconf Command 3–23
3.6.3.1 Options 3–24
3.6.4 Using the netstat Command 3–26
3.6.4.1 Options 3–26
3.6.5 Using the ping Command 3–27
3.6.5.1 Options 3–27
3.6.6 Using the ps Command 3–28
3.6.6.1 Options 3–29
3.6.7 Using the prstat Command 3–29
3.6.7.1 Options 3–30
4. FRU Replacement Preparation 4–1
4.1 Tools Required for Maintenance 4–1
4.2 FRU Replacement and Installation Methods 4–2
4.2.1 FRU Replacement 4–2
4.2.2 FRU Installation 4–4
4.3 Active Replacement/Active Addition 4–5
4.3.1 Releasing a FRU from a Domain 4–5
4.3.2 FRU Removal and Replacement 4–6
4.3.3 Configuring a FRU in a Domain 4–6
4.3.4 Verifying the Hardware Operation 4–7
4.4 Hot Replacement/Hot Addition 4–7
4.4.1 FRU Removal and Replacement (Power supply unit/Fan unit)
4–8
4.4.2 Verifying the Hardware Operation (Power supply unit/Fan unit)
4–10
4.4.3 Verifying the Hardware Operation (Hard disk drive) 4–11
4.5 Cold Replacement/Cold Addition 4–12
4.5.1 Powering off the Server 4–12
To Next Page
Loading...
