Chapter 2 Setting Up XSCF 2-67
The administrator group has platadm, useradm, and auditadm privileges and you
cannot change that. Also the operator group has platop and auditop privileges and
you cannot change that.
Setting timeout
■ Command operation
1. Use the showad(8) command to display timeout period.
2. Use the setad(8) command to set the transaction timeout.
3. Use the showad(8) command to confirm the timeout.
XSCF> showad
dnslocatormode: enabled
expsearchmode: enabled
state: enabled
strictcertmode: enabled
timeout: 4
logdetail: none
<Example> The timeout priod is set to 10 sec.
XSCF> setad timeout 10
XSCF> showad defaultrole
dnslocatormode: enabled
expsearchmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: none
To Next Page
Loading...
