2-68 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
Enabling or Disabling the Logging of Active Directory Authentication
and Authorization Diagnostic Messages
■ Command operation
1. Use the showad(8) command to display the log detail level.
2. Use the setad(8) command to set the log detail level.
3. Use the showad(8) command to confirm the log detail level.
Display the Diagnostic Messages and Clear the Log File
■ Command operation
1. Use the showad(8) command to display the log detail level.
XSCF> showad
dnslocatormode: enabled
expsearchmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: none
<Example1> Enable the log and trace is set for detail level.
XSCF> setad logdetail trace
<Example2> Disable the log.
XSCF> setad logdetail none
XSCF> showad
dnslocatormode: enabled
expsearchmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
XSCF> showad
dnslocatormode: enabled
expsearchmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
To Next Page
Loading...
