Chapter 2 Setting Up XSCF 2-69
2. Use the showad(8) command to display the diagnostic messages.
3. Use the setad(8) command to clear the log file of diagnostic messages.
Change the Active Directory Settings Back to the Default
■ Command operation
1. Use the showad(8) command to display the Active Directory settings.
2. Use the setad(8) command to change the Active Directory setting back to the
default.
<Example> Displays diagnostic messages in real time.
XSCF> showad log -f
Mon Nov 16 14:47:53 2009 (ActDir): module loaded, OPL
Mon Nov 16 14:47:53 2009 (ActDir): --error-- authentication status:
auth-ERROR
Mon Nov 16 14:48:18 2009 (ActDir): module loaded, OPL
...
XSCF> setad log clear
Warning: About to clear log file.
Continue? [y|n]: y
XSCF> showad
dnslocatormode: enabled
expsearchmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
XSCF> setad default -y
Warning: About to reset settings to default.
Continue? [y|n]: y
To Next Page
Loading...
