Chapter 2 Setting Up XSCF 2-89
The administrator group has platadm, useradm, and auditadm privileges and you
cannot change that. Also the operator group has platop and auditop privileges and
you cannot change that.
Setting timeout
■ Command operation
1. Use the showldapssl(8) command to display timeout period.
2. Use the setldapssl(8) command to set the transaction timeout.
3. Use the showldapssl(8) command to confirm the timeout.
Enabling or Disabling the Logging of LDAP/SSL Authentication and
Authorization Diagnostic Messages
■ Command operation
1. Use the showldapssl(8) command to display the log detail level.
XSCF> showldapssl
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 4
logdetail: none
<Example> The timeout priod is set to 10 sec.
XSCF> setldapssl timeout 10
XSCF> showldapssl defaultrole
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: none
XSCF> showldapssl
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: none
To Next Page
Loading...
