2-90 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
2. Use the setldapssl(8) command to set the log detail level.
3. Use the showldapssl(8) command to confirm the log detail level.
Display the Diagnostic Messages and Clear the Log File
â– Command operation
1. Use the showldapssl(8) command to display the log detail level.
2. Use the showldapssl(8) command to display the diagnostic messages.
3. Use the setldapssl(8) command to clear the log file of diagnostic messages.
<Example1> Enable the log and trace is set for detail level.
XSCF> setldapssl logdetail trace
<Example2> Disable the log.
XSCF> setldapssl logdetail none
XSCF> showldapssl
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
XSCF> showldapssl
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
<Example> Displays diagnostic messages in real time.
XSCF> showldapssl log -f
Mon Nov 16 14:47:53 2009 (LdapSSL): module loaded, OPL
Mon Nov 16 14:47:53 2009 (LdapSSL): --error-- authentication
status: auth-ERROR
Mon Nov 16 14:48:18 2009 (LdapSSL): module loaded, OPL
...
XSCF> setldapssl log clear
Warning: About to clear log file.
Continue? [y|n]: y
To Next Page
Loading...
Need help?
General