Chapter 2 Setting Up XSCF 2-91
Change the LDAP/SSL Settings Back to the Default
■ Command operation
1. Use the showldapssl(8) command to display the LDAP/SSL settings.
2. Use the setldapssl(8) command to change the LDAP/SSL setting back to the
default.
3. Use the showldapssl(8) command to confirm the default settings.
XSCF> showldapssl
usermapmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
XSCF> setldapssl default -y
Warning: About to reset settings to default.
Continue? [y|n]: y
XSCF> showldapssl
usermapmode: disabled
state: disabled
strictcertmode: disabled
timeout: 4
logdetail: none
To Next Page
Loading...
