Chapter 2 Setting Up XSCF 2-199
3. The message includes the identification data. Verify that the correct desired
configuration file was selected and answer yes to continue.
4. The XSCF will be reset. After about 10 minutes, the data is restored and the
XSCF halts.
Note – If a serial terminal is connected to the XSCF Unit, you should see the
message, "XSCF BOOT STOP (recover by NFB-OFF/ON)".
5. Turn the input power supply of the server off, then on.
Note – For more about encrypted data, see the man page or the XSCF Reference
Manual of the restoreconfig(8) command.
To Next Page
Loading...
