Chapter 9 How to Use the XSCF Web 9-23
TABLE 9-16 lists the functions for configuring XSCF user management. Select
[Settings]-[User Manager] in the Menu tree.
Note – The login lockout function is not supported by XSCF Web. Set the function
by using setloginlockout(8) and showloginlockout(8) commands.
TABLE 9-16 User Management Configuration
Function Remarks
User accounts list display Displays user accounts information and the state
being registered now. The useradm privilege is
required.
This function is equivalent to the showuser(8)
command.
User accounts addition and deletion Adds and deletes a user account. The useradm
privilege is required.
These functions are equivalent to the adduser(8)
and deleteuser(8) commands.
Enabling/disabling user accounts Enable and disable a user account. The useradm
privilege is required.
These functions are equivalent to the
enableuser(8) and disableuser(8) commands.
User accounts information display and change Displays a user account information and changes
the password, privilege, password policy. The
useradm privilege is required.
These function are equivalent to the password(8),
setprivileges(8), and setpasswordpolicy(8)
commands.
Your own account information display and
password change
Displays information of your own account without
the useradm privilege and changes the password.
These functions are equivalent to the showuser(8)
and password(8) commands.
Password policy display and setting Display the current system password policy. And
set the password policy that will be applied now.
These function are equivalent to the
showpasswordpolicy(8) and
setpasswordpolicy(8) commands.
Privileges for remote user account settings Change the privilege for a user account that is
defined in an LDAP repository.
This function is equivalent to the
setprivileges(8) command.
To Next Page
Loading...
Need help?
General