Chapter 2 Setting Up XSCF 2-17
TABLE 2-2 lists setting items and the corresponding shell commands.
To complete the network settings, the XSCF reset is required. Reset the XSCF by
using the rebootxscf(8) command. After the XSCF is reset, the XSCF session is
disconnected. Please log in again to the XSCF.
TABLE 2-2 Network Configuration
Item Description Shell Command Remarks
Display network Displays XSCF network interfaces.
Also, displays the following network status:
• Number of bytes of the receive queue
buffer.
• Number of bytes of the send queue buffer.
• Local address and port.
• Host address and Socket port number.
shownetwork
showdscp
If the XSCF Unit is
redundant, the
connection status of
the other side is not
displayed.
Enable/disable
network
Enables or disables an XSCF network
interface (see
TABLE 2-1).
setnetwork
setdscp
• When the XSCF
Unit is a
redundant
model, Defaults
of IP address of
ISN are the
following:
XSCF#0:192.168.1.1
XSCF#1:192.168.1.2
•No default
setting has been
specified for the
other interfaces.
•You can use a
single LAN port
for XSCF-LAN.
For network
connection
examples, see
Chapter 3.
•You can remove
the configuration,
XSCF-LAN,
Takeover IP
address, and
netmask
IP address Specifies the following IP address of the
XSCF network interfaces (see
TABLE 2-1).
• One or both of the XSCF-LAN ports
• DSCP
• ISN, Takeover IP address (if a redundant
XSCF Unit is used)
netmask Sets a netmask for an XSCF network
interface.
Display host
name
Displays a host name and the host name
informations.
A Fully Qualified Domain Name (FQDN)
can be displayed
showhostname
To Next Page
Loading...
Need help?
General