2-34 SPARC Enterprise Mx000 Servers XSCF User’s Guide • January 2012
Note – You can set the IP filtering rules to the input packets, not to the output
packets.
Applying the XSCF Network Settings
■ Command operation
1. After performing the setnetwork(8), sethostname(8), setroute(8), and
setnameserver(8) commands, apply these Network settings.
2. Perform the applynetwork(8) command on the XSCF Shell. When performing
the command, the network settings are displayed and you can confirm whether
the settings should be applied.
Note – When the XSCF Unit is in redundant configuration, ISN addresses must be
in the same network subnet.
3. Use the rebootxscf(8) command to reset the XSCF and to complete the settings.
XSCF> applynetwork
The following network settings will be applied:
xscf#0 hostname :scf0-hostname
DNS domain name :company.com
nameserver :10.0.0.2
nameserver :172.16.0.2
nameserver :192.168.0.2
search :company1.com
interface :xscf#0-lan#0
status :up
IP address :192.168.1.10
netmask :255.255.255.0
route :-n 192.168.1.0 -m 255.255.255.0 -g 192.168.1.1
interface :xscf#0-lan#1
status :down
IP address :
netmask :
route :
Continue? [y|n] :y
To Next Page
Loading...
