7. INITIAL SETTINGS
7-13
6. Press the or key according to the direction of rudder movement found in
step 4.
The message shown below appears.
7. Turn the helm or press the or key hard-over to PORT/STBD then push
the Course control knob.
The message shown below appears.
8. Long press the or key hard-over in the op-
posite direction from step 7.
While pressing a key, the message shown right ap-
pears.
Note: Hold down the key more than three seconds.
When you release the key within three seconds,
the message shown right appears. Push the
Course control knob and go back to step 7.
9. When the rudder reaches the hard limit, release the
or key to display the message shown right.
10. Do one of the following.
• If the rudder reached the hard limit properly
: Push
the Course control knob. After pushing the knob, the message shown below
appears according to the key pressed at step 8.
• If the rudder did not reach the hard limit properly
: Press the key to show the
following message.
If retry the rudder test, push the Course control knob and go back to step 7. If
not, press the key to abort the rudder test.
Move rudder to PORT or
STBD hard limit by using
wheel or arrow key.
Move Rudder
Rudder at Hard limit
Abort
Push and hold arrow key
pressed to mode rudder
to oppsite hard limit.
Move to STBD
Abort
Move to PORT
Don’t release the key until
the rudder has reached the
hard limit!
Rudder test is uncompleted.
Retry?
NoYes
Has the rudder reached
the hard limit?
NoYes
Push and hold arrow key
pressed to mode rudder
to oppsite hard limit.
Abort
Move to PORT
Push and hold arrow key
pressed to mode rudder
to oppsite hard limit.
Move to STBD
Abort
key is pressed at step
8 key is pressed at step
8
Rudder test is uncompleted.
Retry?
NoYes
To Next Page
Loading...
